Oil Change

[MikeTurbo]

I need to change the oil in my 2000 turbo classic and been told it's not a
simple job or can i just empty out and bung new in.?:innocent0009::confused:

[Torpedo]

you need to pm oilman


http://www.southwestscoobies.org.uk/member.php?u=132


; )

[steve555]

Simple job mate.

Get car up to normal operating temp. so as to let oil circulate.
Drain oil via sump bung (17mm)
Remove oil filter (right beside sump)
Pre-fill new oil filter (take your time as it takes quite a bit)
Fit oil filter hand tight
Fit sump bung with new crush washer
Fill oil

Job done :cool:

[worker]

Simple job mate.

Get car up to normal operating temp. so as to let oil circulate.
Drain oil via sump bung (17mm)
Remove oil filter (right beside sump)
Pre-fill new oil filter (take your time as it takes quite a bit)
Fit oil filter hand tight
Fit sump bung with new crush washer
Fill oil

Job done :cool:
u need to disconect the crank sensor to prime the oil round the engine so u dont get air locks in the crank cusing bigend failer:redface:

[beachsleeper]

u need to disconect the crank sensor to prime the oil round the engine so u dont get air locks in the crank cusing bigend failer:redface:

Very inportant, this last bit. Only takes a minute or two, to dry crank the engine without firing, oil pressure light will go off. And off you go. Well check for leaks before you blast the scoob.

[MikeTurbo]

Thanx for your info about my oil change chaps i'll get my hands dirty the
weekend CHEERS.:happy0061: